crate engines good or no?
#2
RE: crate engines good or no?
They are good, as long as you get it from a good builder / dealer. Did you have any in mind? How much you looking to spend?
Try these guys: http://www.tandlengines.com
Try these guys: http://www.tandlengines.com
#4
RE: crate engines good or no?
id only fool with a local machine shop, even if it was my block coming out my car to him for mods.
If I had a decent camera, Id show you how these guys TAKE THIER TIME and precision is a key factor.
There is not a spot of dirt anywhere. I watched as they did this 347 stroker block and used 3 different torque wrenches just to verify torque.
And after one machinist was done, another checked over his work to verify. Id never get a motor from a dam assembly line
If I had a decent camera, Id show you how these guys TAKE THIER TIME and precision is a key factor.
There is not a spot of dirt anywhere. I watched as they did this 347 stroker block and used 3 different torque wrenches just to verify torque.
And after one machinist was done, another checked over his work to verify. Id never get a motor from a dam assembly line
#5
RE: crate engines good or no?
why three tq wrenches...most machine shops send out there tq wrenches for certification every 3 mo's,and most use two types
assembly lines for 302's were built pretty damn good.
assembly lines for 302's were built pretty damn good.
#7
RE: crate engines good or no?
what 10yrs ago?....the dies that were bought from ford only have a certain life span before new inserts are needed..
i had been a die changer for 6yrs and at most they only last 8000 shot's and iv'e seen some last 500.
i had been a die changer for 6yrs and at most they only last 8000 shot's and iv'e seen some last 500.
Thread
Thread Starter
Forum
Replies
Last Post
Faolan65
New Member Area
2
08-27-2015 06:40 AM
Faolan65
Arizona Regional Chapter
0
08-25-2015 09:24 AM
HIS S-197
4.0L V6 Technical Discussions
1
08-10-2015 05:47 PM