smokesricers

will the 8.8inch be able to handle a 347 stroker from D.S.S. racing. If not should i spend the money for a 9inch or just beef up the 8.8?

nmerrill

beef up the 8.8. For the money it would take to modify a 9' to bolt up to your fox you could make that 8.8 pretty stout

smokesricers

What should i use to beef it up?

HACKGT350

it will be fine you shouldnt have a problem and i think the 9" bolts right up anyway

nmerrill

i thought the 9' rear ends were from leaf spring suspension. I could definately be wrong though. Well just run it till the 8.8 breaks then throw some 31 spline shafts, a nice locker, and gears in there

Stanpower

I think the 8.8 rear will be fined..Why waste the money?

HACKGT350

you can buy a brand new 9" that will bolt up fine

AdderMk2

31 spline axles, Eaton tru-trac differential, and a new set of gears

luckythirteen13

and new bearings

94gtcoupe

i read an article in a magazine (can't remember which one) but this guy have a low 10 high 9 sec. car with a stock 8.8 from a 94-95 with a nice locker in it and it held just fine, i think you'll be ok with the 8.8 maybe a nice diff. and thats all you'll need