a few misc engine questions
#1
a few misc engine questions
Hey... My getting done redoing my 91 5.0 and need a few things. The torque pattern for the heads... I have some water pump bolts but aren't sure which bolt goes where If anyone has a pic or something that could help me out. thanks. I torqued a oilpan bolt down too hard and broke it off in the block What do I do. Thanks
#2
RE: a few misc engine questions
Well i would start by getting a chilton or haynes manual, they are your best friends when building an engine. That oil pan bolt will have to be fixed or you will leak oil. I would suggets taking the pan off and either drilling and ez out/tapping, or vise grips depending on how much bolt is sticking out
#4
RE: a few misc engine questions
haynes manuals for fox mustangs suck, i've never used a chiltons though
-I realize how crude this is but i dont have a scanner otherwise i would email the actual book pages
-torque in two steps 1) 56-65 ft./lbs 2) 65-72 ft./lbs (torque specs may be different for aluminum heads)
intake
manifold
9 5 1 3 7
10 6 2 4 8
headers
ten bolts on each head, 1 and 2 are the middle bolts
-I realize how crude this is but i dont have a scanner otherwise i would email the actual book pages
-torque in two steps 1) 56-65 ft./lbs 2) 65-72 ft./lbs (torque specs may be different for aluminum heads)
intake
manifold
9 5 1 3 7
10 6 2 4 8
headers
ten bolts on each head, 1 and 2 are the middle bolts
Thread
Thread Starter
Forum
Replies
Last Post
HIS S-197
4.0L V6 Technical Discussions
1
08-10-2015 05:47 PM