SN95 hub/bearing question
#1
SN95 hub/bearing question
Got a pair of SN95 spindles & hubs for a 5-lug conversion. I took the hub off the spindle to check the bearings. Needless to say, I ruined the 'nut keeper' thingy. I did manage to get the four thin nuts off without ruining them, though.
Is there a rebuild kit available with a new 'nut keeper' thingy? Do I need it?
Also, does anyone know the torque spec for putting the nuts back on?
Is there a rebuild kit available with a new 'nut keeper' thingy? Do I need it?
Also, does anyone know the torque spec for putting the nuts back on?
Thread
Thread Starter
Forum
Replies
Last Post
Tap
4.6L (1996-2004 Modular) Mustang
0
08-05-2005 08:54 PM