a arms and control arms
#1
a arms and control arms
I know i need new ball bearing on my stang. i know that the ball joint is on the control arm and its recommended to replace the whole arm. what i don't know is whats an a arm?
#5
RE: a arms and control arms
i was reading older posts and people on it said it was better to replace the whole thing... i have veritcle wobble in my tires alot. when i am on the highway its hard to stay in the lane sometimes it so bad.
#7
RE: a arms and control arms
this is what you are looking for...
http://www.themustangshop.ca/site/ca...umber=TTMwNzVE
when i went to do mine last year...the entire usa and canada were backordered....go figure...
http://www.themustangshop.ca/site/ca...umber=TTMwNzVE
when i went to do mine last year...the entire usa and canada were backordered....go figure...
#10
RE: a arms and control arms
when i did mine i jacked uder the K-Member...then blocked the car on the reinforcement plate under the drivers and passengers floor...near wherethe door meets the fender.....do not reley on just a jack for support.
you can see my block points in this pick of my parts stripper car..
http://i128.photobucket.com/albums/p...y122006013.jpg
you can see my block points in this pick of my parts stripper car..
http://i128.photobucket.com/albums/p...y122006013.jpg