head question?!
#11
RE: head question?!
ORIGINAL: stocksuspension
so what do i bore to if its anluminum block?
so what do i bore to if its anluminum block?
#12
RE: head question?!
when cutting 2.02 chevy valves, what angle am i cuttin to
ORIGINAL: AdderMk2
you would have to ask ron and steve. I only did head milling, porting, valve jobs, parts ordering.. and loading the chem washer and tumbler
ORIGINAL: stocksuspension
so what do i bore to if its anluminum block?
so what do i bore to if its anluminum block?
#14
RE: head question?!
oh i thought i was clear when i said 2.02 chevy valve! wow 9 degrees! u just proved to me u dont do valve jobs.. ur a smart guy.. u dont have to know everything... but what pisses me off!!!!!!!!!!!!! is that u claim to be everything and know everything! and when some one asks a question u smash on them like if theyere stupid.. for once quit being stupid and cocky and help out homeoboy(s)....i aint saying this to be a dick but someone had to say it.... i didnt do this post to stirrup a contreversy but as a fellow technition i have r&r ur attitude
ORIGINAL: AdderMk2
well that depends on which valve is used... manley valves are 10° and some ferrera valves are 12°, while other ferrera valves are 9°... but those are the flat head valves
well that depends on which valve is used... manley valves are 10° and some ferrera valves are 12°, while other ferrera valves are 9°... but those are the flat head valves
Thread
Thread Starter
Forum
Replies
Last Post