95gtspony

i recently got a 95 gts and its got 155k miles on it but the engine runs strong but what can i do to make it better? it is bone stock but i am adding flowmaster cat-back, pulleys, headers, and springs. Is this a good idea. Also i have slack in my steering and when i make turns something pops anyone know what that is ?

Obsol3te

GTS?
That an Eclipse or somethin?

95gtspony

no its a 95 mustang gt with the 5.0 but with not options so its lighter

Obsol3te

Well, as with any stang a nice set of rear end gears would do wonders
And a Full exhaust too!
That should run you a little bit, but both are great mods

86HOGT

The popping around corners is most likely due to a worn out ball joint.

89lx302

the poping around corners sounds like CVjoints to me.

tyybo

do the 95s have cv joints?

86HOGT

Cv joints!? That's a good one!

Aliate X

Yeah i get that same poping, but only when im on the brakes at low speed and i take a hard turn. So ball joints you say?

cammedlx

since when did they start making mustangs front wheel drive[8D]and yeah that does sound like the ball joints but im not sure if they will cause play in you steering wheel like that if i was you i would just rebuild the whole front end with new inner and outer tie rods and maybe a new centerlink also oh yeah don't forget the the ball joints