junknotch

this is what I found on my project
before
http://i108.photobucket.com/albums/n...000_0093-1.jpg
http://i108.photobucket.com/albums/n...r/000_0094.jpg
after
http://i108.photobucket.com/albums/n...Picture016.jpg
http://i108.photobucket.com/albums/n...Picture010.jpg

these are just a few I found major rust and rott finally got it all done had to replace the rocker panels a quater panel, piece out of the roof, and much more. The car is ready for paint now and should be done by the end of the month. Then on to the interior and suspension. Then next year the motor and trans and rear end.

92hatchLX

Looks like you're going to need tie rod ends and ball joints too.

Li0nHart

fortunately....all that stuff you need to replace is merely bolt on....hows the rest of the body...if you gotta weld up floor pans, rockers, quarters, etc...you got a big job on your hands.

goathead75

That **** will buff out.

AdderMk2

Bust out the PBlaster... its gonna be a long night!

AlabamaCobra

hah it looks like the coil spring have had it too, i bet the body is in shyt condition.

FivePointOhh

if i find a camera i'll show you a shyt body, the harder ilook the more bad news....i think i might build up what i got on the drivetrain and then find a good rolling chassy for sale

goathead75

+1 that stuff rules! In fact, it's working for me right now so I can swap out my h-pipe.

stang2race

Actually the body is solid and clean, just a horrible paint job that has seen better days.most of the under body had rust protectant on it and after scraping it away it looks like new sheet metal. crazy huh.