Thinking about getting a turbo... opinions on this few
#12
RE: Thinking about getting a turbo... opinions on this few
ORIGINAL: CrazyCobraSpeed
haha thats funny.... who has good customer service then??
ORIGINAL: r.barn
Crazy, read thru all the post at this link
http://www.theturboforums.com/smf/in...amp;board=10.0
You will see that HP and PTK make good kits but have AWEFUL customer service
and delivery problems.
Turbo companies have gotten so bad with customer service that turbomustangs.com
set up a whole forum section just for people to bitch.
Crazy, read thru all the post at this link
http://www.theturboforums.com/smf/in...amp;board=10.0
You will see that HP and PTK make good kits but have AWEFUL customer service
and delivery problems.
Turbo companies have gotten so bad with customer service that turbomustangs.com
set up a whole forum section just for people to bitch.
haha thats funny.... who has good customer service then??
#14
RE: Thinking about getting a turbo... opinions on this few
If you are worried aboust the block holding up just buy a d.s.s. main support it requires no machine work to the caps and almost doubles the strenghth of the bottom end. That is whatI did when I installed my V-1 @ 9#s of boost. I have not had any problems at all.
#16
RE: Thinking about getting a turbo... opinions on this few
Don't forget to think of all of the other things you're going to have to upgrade with that kind of power. Beyond just the motor
http://hellionpowersystems.com/
http://hellionpowersystems.com/
#18
RE: Thinking about getting a turbo... opinions on this few
ORIGINAL: CrazyCobraSpeed
haha thats funny.... who has good customer service then??
haha thats funny.... who has good customer service then??
and
www.hellionpowersystems.com - they say thier 94-95 kit is in testing right now and due out soon.
#19
RE: Thinking about getting a turbo... opinions on this few
ORIGINAL: BLUEPONY5.0
If you are worried aboust the block holding up just buy a d.s.s. main support it requires no machine work to the caps and almost doubles the strenghth of the bottom end. That is whatI did when I installed my V-1 @ 9#s of boost. I have not had any problems at all.
If you are worried aboust the block holding up just buy a d.s.s. main support it requires no machine work to the caps and almost doubles the strenghth of the bottom end. That is whatI did when I installed my V-1 @ 9#s of boost. I have not had any problems at all.
Thread
Thread Starter
Forum
Replies
Last Post