Dyno tune...finally - Page 2 - MustangForums.com

5.0L (1979-1995) Mustang Technical discussions on 5.0 Liter Mustangs within. This does not include the 5.0 from the 2011 Mustang GT. That information is in the 2005-1011 section.

Dyno tune...finally

Reply

 
 
 
Old 05-08-2007, 04:00 PM
  #11  
LTnone
4th Gear Member
Thread Starter
 
Join Date: Jul 2006
Location:
Posts: 1,897
Default RE: Dyno tune...finally





One thing that surprised me was that power dropped off after 5,400rpm, which was about 400 lower than I was expecting. To make a better case for the necessity of a tune, look at RunFile_001. That was a baseline pull before any tuning was done. Little difference?
LTnone is offline  
Reply With Quote
Old 05-08-2007, 04:05 PM
  #12  
VigCS
5th Gear Member
 
Join Date: Jun 2005
Location: Frederick, Maryland.
Posts: 2,118
Default RE: Dyno tune...finally

Nice numbers!
VigCS is offline  
Reply With Quote
Old 05-08-2007, 04:15 PM
  #13  
greenstreak9205
4th Gear Member
 
Join Date: May 2006
Location: Waterford, WI
Posts: 1,485
Default RE: Dyno tune...finally

what were the numbers before the tune? it wasn't the 238 was it?
greenstreak9205 is offline  
Reply With Quote
Old 05-08-2007, 04:18 PM
  #14  
ruger311
4th Gear Member
 
Join Date: Apr 2006
Location:
Posts: 1,770
Default RE: Dyno tune...finally

nice numbers man looks great!
ruger311 is offline  
Reply With Quote
Old 05-08-2007, 08:53 PM
  #15  
LTnone
4th Gear Member
Thread Starter
 
Join Date: Jul 2006
Location:
Posts: 1,897
Default RE: Dyno tune...finally

ORIGINAL: greenstreak9205

what were the numbers before the tune? it wasn't the 238 was it?
That's the one. The runs are printed out on the sheet 2,3,1 from top to bottom. One one hand my timing was pretty retarded at that point, but ~65hp is a pretty big difference either way
LTnone is offline  
Reply With Quote
Old 05-08-2007, 09:10 PM
  #16  
CHILLERMAN
1st Gear Member
 
Join Date: Dec 2006
Location:
Posts: 103
Default RE: Dyno tune...finally

Good numbers. My final results were very close to yours. I was a little lean about 14:1 when I came in for the baseline. However I only needed a fuel press. adjustment to correct things and that was it.
CHILLERMAN is offline  
Reply With Quote
Reply
 
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
articman
General Tech
1
06-21-2018 11:45 PM
Galactic
Mustangs For Sale
9
03-30-2017 06:44 PM
heslekrants
Street/Strip
11
09-23-2015 04:02 PM
The01Cav
North East
0
09-05-2015 03:39 PM
The01Cav
Maryland Regional Chapter
0
08-31-2015 04:12 PM

Forum Jump

Thread Tools
Search this Thread
Advertising
Featured Sponsors
Vendor Directory