Door lock acuators
Has anyone replaced them, and how do you remove them. Do you drill out the rivit or does it come out from the bottom of the holder inside the door?
|
RE: Door lock acuators
I was wondering the same thing cause mine dont work either.
|
RE: Door lock acuators
I took the panel off the door, but I don't see how they come out either.
|
RE: Door lock acuators
i know in my sn-95 i i was able to remove them from the bracket that was riveted to the door without breaking the rivet, its a pain but you just spread the two side pieces of the mount enough to slip it out.
|
RE: Door lock acuators
O.k., I will check that out. Thanks
|
RE: Door lock acuators
take of dorr panel
disconnect actuator drill rivet from outside there is a white clip that is held by the rivet inside the door that clips the the actuator then put on a nother rivet. (iv done this about 4 times on each side on my car) hope that explaines |
RE: Door lock acuators
so I can't seperate or spread thewhite clip apart and just get the actuator out like mentioned before. does the new actuator include a new clip.
|
RE: Door lock acuators
best bet is drilling out the rivit, but you need a serious rivit gun for the new ones, the 50 resto kit doesnt come with the clip if i remember correctly,
|
RE: Door lock acuators
o.k. thnaks alot.
|
RE: Door lock acuators
You should be able to just pull it off. I do it on my other fords all the time why bother drilling out a rivet when you can just pull and it come off? There are two white plastic bushings that go on either side of the door lock and they slide into a groove on the metal part that is riveted to the door just make sure you don't lose the plastic pieces
|
All times are GMT -5. The time now is 07:38 AM. |
© 2024 MH Sub I, LLC dba Internet Brands