Has anyone put the HVAC in the ash tray.....?
#1
Has anyone put the HVAC in the ash tray.....?
Has anyone put the HVAC knobswhere the ash tray is and then put gauges where the original ***** were?
I thought i saw a picture on here or somewhere, where someone had done that
Does anyone have this picture?
How would you go about doing this?
Thanks
I thought i saw a picture on here or somewhere, where someone had done that
Does anyone have this picture?
How would you go about doing this?
Thanks
#5
RE: Has anyone put the HVAC in the ash tray.....?
ORIGINAL: BlackBetty93GT
I like that....
but no, doesnt count...im trying to find that picture again
and figure out how to do it
I like that....
but no, doesnt count...im trying to find that picture again
and figure out how to do it
#7
RE: Has anyone put the HVAC in the ash tray.....?
What exactly would the point of that be anyway?
You can get thecontrol/stereo flip plate that relocates the controls to below the stereo if the stereo location is your concern.
You can get thecontrol/stereo flip plate that relocates the controls to below the stereo if the stereo location is your concern.
#8
RE: Has anyone put the HVAC in the ash tray.....?
it wouldnt be hard at all. just take the whole HVAC control head, and move it to the ashtray. you'll have to fabricate some brackets and stuff, after that, just splice and add wire/vacuum hose. just make sure the vacuum hoses dont get pinched when you run them thru the console
Thread
Thread Starter
Forum
Replies
Last Post
1996cobraconvertible
SVT Forums
13
01-07-2016 04:50 AM
AmericanMuscle4.6GT
2005-2014 Mustangs
7
11-10-2015 02:06 PM
LivingInThePast
Classic Mustangs (Tech)
2
09-16-2015 12:20 PM