94StinkinLincoln

well its just the sensors and small stuff like vac lines. i got to get a bolt for the alternator, a retainer clip for the fuel line, and block a couple vac line holes, and that should be it. my dad and i are going to work on it in the morning. would it be ok for it to idle in the yard while we check everything is ok and nothings leaking? i just dont want to idle it to much. yea its taking me for freakin ever! i kno...its my first time but i fu@#ed myself by waiting a couple months to put it together after taking it apart and since i used my dads shop and he works in it i had to move stuff back and forth every time i worked on it...i lost an *** load of bolts and trying to remember where everything goes is like a damn jigsaw puzzle! i didnt lable...wont make that mistake again!!!!

iceman89gt

yea it will be fine to check for leaks and all just dont go ******* it without a tune. if i werent racing tommorow i would ride over and give you one of the 10 altenator bolts i got and one of the 20 fuel line clips and a couple packs of the vaccum line block off nipples in assorted sizes

94StinkinLincoln

i got enough plugs, i just hope we got all this stuff hooked up right lol. i told my dad i was gonna get a mustang guy to the house to get this damn thing done and hes like we can do it, it will just take us a little longer. i havent been to the track in forever but i was kinda waiting to go till i got done w/ the car. it would be nice if u could come over when i go to drive it for the first time and make sure everything goes ok. im on vacation till wed. u busy monday? how much gas $ ya need?

iceman89gt

im free monday and as far as the gas dont worry about it i was just kidding, i will come over and see ya through it all. i will pm you my cell so we can confirm sunday. im racing tommorow at state capitol then tommorow night at no problem and then again sunday at state capitol but monday i will be free to check ya out.

AdderMk2

Matt was correct. #2 is the EEC test port, and #3 DOES go to the evap canister.

I'll go outside in a few and figure out what #1 is.

Joel5.0

#1 looks like one of the connectors of the ABS control module.