cvp88ranger

hey everybody im a newbie to this forum. Ive been having trouble with my ranger since i swapped in a 5.0 EFI.
so i replaced the ignition module today with a Accel module since thats the problem the diagnostic came up with. I have already replaced the ignition module once in November.
Once i installed it i fired up the truck it got up to operational temp and was running really good, after about 25 mins i turned the truck off.
Then i went to fire the truck back up and it wont start, it sounds like it did b4. I am so confused i knew the ignition module wasnt the problem.
Another thing is once the truck is cold it will start up usually.

5.0mustang5speed

maybe the coil is heating up...

86HOGT

Maybethe timing is too advanced to hot start it...who knows...

Culd you tell us a little more...like how fast is is cranking...sputtering, not starting...etc...

88GT40

did you install a mustang ecu?

cvp88ranger

yea i installed a mustang ecu.
hmm i dont think the coil is heating up its in the spot where the 4cyl one was.

maybe its the pickup in the distributer?

1BADASSLX

your prob wright i had same prob one time i change distributer and it fixed it but it might of been the pick up!

cvp88ranger

sweet ill go ahead and replace that then.