how hard is it to install c-clip eliminators???
#1
how hard is it to install c-clip eliminators???
what do use,just a hacksaw? i ordered strange 31,studs,eliminators,and carrier.
i forgot to order a seal kit can i get one from napa?
i forgot to order a seal kit can i get one from napa?
#3
RE: how hard is it to install c-clip eliminators???
I used a side cutter. or some people call it a wiz wheel.I took tape and wraped it around the tubes and used that as a guide for how much needed to come off.and to help keep things straight
#7
RE: how hard is it to install c-clip eliminators???
yepper i sur did,cause i'm going to take my ol'ones and wrap them around itty bitty neck!
j/k my driver side is bent worse than i thought
j/k my driver side is bent worse than i thought
ORIGINAL: Stinger
You went with axles ?heheheh
You went with axles ?heheheh
#8
RE: how hard is it to install c-clip eliminators???
No they are not that bad to do posi-unit Iam not sure what you mean.but I got a spool in my car so it was cake.my bearings were already pressed on my axles so that was good all I had to do was cut the tubes and bolt the axles to the housing make sure you level the end of the tubes after you cut them and use lots of sealer so the ends dont leak. if that is the way yours is done.I had to leave 1/4 in on the end of the tube and that would go up into the c-clip eliminator.
#9
RE: how hard is it to install c-clip eliminators???
ORIGINAL: grabbem88
what do use,just a hacksaw? i ordered strange 31,studs,eliminators,and carrier.
i forgot to order a seal kit can i get one from napa?
what do use,just a hacksaw? i ordered strange 31,studs,eliminators,and carrier.
i forgot to order a seal kit can i get one from napa?
#10
RE: how hard is it to install c-clip eliminators???
i was talking about the carrier (eaton posi).......
ORIGINAL: uedlose
No they are not that bad to do posi-unit Iam not sure what you mean.but I got a spool in my car so it was cake.my bearings were already pressed on my axles so that was good all I had to do was cut the tubes and bolt the axles to the housing make sure you level the end of the tubes after you cut them and use lots of sealer so the ends dont leak. if that is the way yours is done.I had to leave 1/4 in on the end of the tube and that would go up into the c-clip eliminator.
No they are not that bad to do posi-unit Iam not sure what you mean.but I got a spool in my car so it was cake.my bearings were already pressed on my axles so that was good all I had to do was cut the tubes and bolt the axles to the housing make sure you level the end of the tubes after you cut them and use lots of sealer so the ends dont leak. if that is the way yours is done.I had to leave 1/4 in on the end of the tube and that would go up into the c-clip eliminator.