engine question quick help before tommorow morning
#1
engine question quick help before tommorow morning
so i got my block stripped down to nothing, about to put on my new trickflow heads...do i need new roller lifters, push rods and rockers for it?? i have everything else to do the hci and
#2
RE: engine question quick help before tommorow morning
Lifters are recommended.... But not nessecary. Just make sure when you install them they go in the EXACT way they came out. This means it needs to go back in its original hole and the roller needs to spin the same way. Then I would do a good set of roller rockers (ratio depending on your cam) When all is said and done, get an adjustable pushrod and find the correct length and order them last. Thats the proper way to do an HCI
Thread
Thread Starter
Forum
Replies
Last Post
NorthAmericanTuning
Vendor For Sale / Group Buy Classifieds
5
11-09-2016 11:45 AM
NorthAmericanTuning
S550 2015-2023 Mustang
3
03-18-2016 11:21 AM