WesDe

OK. Now that I have checked the TPS it shows 1.085V so I need to adjust it. The problem is that the two phillips screws that are holding it down are stuck. I tried all types of scredrivers and can not move them. They are strarting to strip on the inside so Im afraid to use a drill. Anyone know a trick to get these loose? Is there another way to adjust the TPS? Please help.

grabbem88

with tester hookedf up you can tap it with a screw driver unless its way tight.

WesDe

I tried that. It is stuck. It has not been taken off since new. Any other ideas??

89stanglx

Any room for vise grips on the head of the secrew? Or use a dremmel and make a notch to fit a larger flattip screwdriver.

WesDe

That would work but I don't have a dremmel>

grabbem88

well if you tear it up i have a brand new one for ya actually two,but i'm keeping one so i got you covered...forgot what i paid...$20 bucks ok?

WesDe

Sounds good will let you know tomorow. Im going to see if I can bang on it and if it breaks then I'll take yours.

grabbem88

wait isn't 94's diff than the 88's?..........

WesDe

Its on a different location but I think it is the same. Either way I will let you know the part number. I think that there is two diferent numbers.

roundman

try soaking the two screws with some good penetrating oil, like Liquid Wrench and see if this doesn't help get them loose.