shift light help
Ok so I hooked everything up and wired my shift light up. I need help figuring out which # to program in, I assume its 4 but not really sure...the directions are as follows:
PULSE PER REVOLUTION SET (CYL. CALIBRATION) – Use this feature to calibrate your Digital Pro Shift System to your engine and ignition type. To enter Pulse Per Revolution Set, press the MODE (+) button until “PPr” is displayed, then press ENTER to confirm your selection. You may now use the “+” and “–” buttons to cycle up and down through the pulse settings available on this product. Pulse per revolution settings refer to the number of pulses or “plug firings” provided by the ignition to the device per engine crank revolution. For example a single coil ignition on a 4-cylinder engine will typically fire two cylinders per crank revolution. If your ignition matched this type, you would need to set your PPr value to “2” ( * See below). Below is a list of common ignition pulse settings * The available ignition pulse settings are .5, 1, 1.5, 2, 2.5, 3, 4, 5 & 6. |
RE: shift light help
bump
|
RE: shift light help
anyone? I guess I will call autometer...
|
RE: shift light help
4
|
RE: shift light help
thanks! thats what I was thinking, just wasnt sure
|
All times are GMT -5. The time now is 10:50 AM. |
© 2024 MH Sub I, LLC dba Internet Brands