Egr elimination resistors??
#1
Egr elimination resistors??
looking to eliminate the the CEL light on with the egr valve disconnected. would like to wire in my own resisters so that i can hide them inside the loom. i know the EVR, CANP, TAB & TAD solenoids use just 75 ohm 3 watt resistors. but cannot find what the egr elimination uses. have seen there were a few pictures up of schematics but they are no longer viewable. I am completely replacing my engine harness and want this stuff cleaned up. Any help is greatly appreciated.
#3
RE: Egr elimination resistors??
Use this drawing, I made mine with this. But you say you have an 87...those don't have a CEL so you will be wasting your time.
[IMG]local://upfiles/29310/DDC4C08E49A446B597641C1D34C40388.gif[/IMG]
[IMG]local://upfiles/29310/DDC4C08E49A446B597641C1D34C40388.gif[/IMG]
Thread
Thread Starter
Forum
Replies
Last Post
trashxtrash
4.6L (1996-2004 Modular) Mustang
4
09-20-2015 10:49 PM
tj@steeda
Steeda Autosports
0
09-17-2015 07:57 PM
TfcCDR
V6 (1994-2004) Mustangs
1
09-14-2015 12:08 PM