Cobra 1.7 RR torque specs??
#1
Cobra 1.7 RR torque specs??
Well, the 89 (not my 90) is getting a set of 95 Cobra heads going on tommarow... Its already got a C/I, and we'll see what happens.
Anyway, does anyone have the proper torque specs for the factory 1.7 Crane roller rockers? They are the pedestal mount ones...
Anyway, does anyone have the proper torque specs for the factory 1.7 Crane roller rockers? They are the pedestal mount ones...
#4
RE: Cobra 1.7 RR torque specs??
if preload isn't reached at proper level..shims will be needed..but if the heads have never been milled or a valve job performed it should all fall right into place
#5
RE: Cobra 1.7 RR torque specs??
I'm pretty sure the valves haven't been done (they were lapped), but some surface was machined off to clean them up...
Thanks for your help though...
I'll try to take some pics as we are doing them... hopefully we'll be done tommarow night...
Thanks for your help though...
I'll try to take some pics as we are doing them... hopefully we'll be done tommarow night...
Thread
Thread Starter
Forum
Replies
Last Post