LCBlackDep183

K the countdown is on, in 4 days ill be doing my SC. Just nailing down some of the final details of the install. Now im running a 12lb pulley with the fmu. I have a set of 42lb injectors with a matching c&l MAF should I go ahead and step up to the larger injectors and adjust the FMU to compensate or should i stick with the 19s?

telsonman

if it were me, i would leave in the 19s until you do your swap

OnyxCobra

I would definitely step up to the 42lbers, 19's is too small for forced induction.

kennebell92conv

put the 42 in and get thestang tune

mjr46

do the injector swap and the s/c all at once and then have it tuned accordingly

PRO50SC

Get rid of the c&land get a p-mas blow thru mass air. Trust me, been there done that!! JD's performance for about 255.00

LCBlackDep183

I plan on getting it tuned eventually but for now im going to run the fmu. And i will get a blowthrough as well, the only reason im looking to do this for now is to take care of it all at once. Im also worried about pushing a ton of fuel pressure through my rails as i've had a problem with one of the injectors leaking. so with the 42s im just wondering if FOR NOW i can run them safley with the fmu(its adjustable to be ran with bigger injectors) and the c&l maf.

PRO50SC

Yes, you can. I ran mine like that for a while, it's just not the best combo.