Carb style intake
#11
RE: Carb style intake
ORIGINAL: r.barn
Those elbows were designed to put the TB in
"stock" location when mounted to a Spyder (aka Vic.Jr.) intake
You should be fine. since that one was shortend you might need
to put an EGR plate on there to push TB out a little so thrtl cable will clear fuel rails.
Those elbows were designed to put the TB in
"stock" location when mounted to a Spyder (aka Vic.Jr.) intake
You should be fine. since that one was shortend you might need
to put an EGR plate on there to push TB out a little so thrtl cable will clear fuel rails.
#12
RE: Carb style intake
ORIGINAL: tinman
Single plane intakes usually kill some low-end torque so be careful there.
Just for an 'experiment' I'd use a daul plane of some sort, maybe a Wyiend 'Stealth'......
Single plane intakes usually kill some low-end torque so be careful there.
Just for an 'experiment' I'd use a daul plane of some sort, maybe a Wyiend 'Stealth'......
Thread
Thread Starter
Forum
Replies
Last Post
uberstang1
Classic Mustangs (Tech)
6
09-20-2015 06:42 PM
Daddys Girls GTs
5.0L (1979-1995) Mustang
3
09-14-2015 08:46 PM
jaiidutch
Motor Swap Section
2
09-14-2015 10:29 AM