ive_escaped

thanks for all of the help, will be looking more into the pony down kit for my car, as well as a good build up to move toward the 600 to 750 hp range. I called and spoke with a guy at pony down and he answered all of my questions. Fellas, he said basically the same as all of you guys, so hats off to ya all, thanks again.

86 5.0L

plan on an aftermarket block if you plan for 600-750hp

greenstreak9205

agreed. aftermarket block for that power range or go 351. you'd be close to maxing out the block at that point (for the 351)

ive_escaped

Going with 351/408 all forged crank, h beam rods, weisco pistons, still questioning the heads, intake system, dart, edelbrock, trick flow, bill mitchell, ????? any suggestions. Also, with a bulletproof bottem end balanced to 8K rpm can i run 9.5 or 10:1 compression or will that be too much or a single turbo set up, any advice?