GIRK_88

can someone tell me where the vacum line on the back of a bosch bypass valve should go if you are not running a fmu? its a powerdyne blower that im changing to a 2.87 pulley which is about 10lbs of boost that blower doesnt come with a bp valve for a 6lb pulley so im going to fabricate the plumbing to recycle the air but just wasnt sure where to go with the vacum line THANKS

FoxGT

The line will connect to any fitting after the throttle plate

GIRK_88

THANK YOU theres a fitting just after the throttle plate where my boost line ties to, this would be a good location then ?

silver91gt

yeppers, it just need any vac/boost signal