stuck on intake for my 347?!?
#1
stuck on intake for my 347?!?
in the process of building a 347. ported victor jrs with the 2.05 intake valves, custom cam from jay allen, 36lb injectors the all deal. im just pulling my hair out over what intake to buy. i really like the victor 5.0 intake or the trick flow r series. i seen those spyder intake manifolds but then seem like too much money and hassle. i also dont want any intake to be crossing the overkill line. looking to spin the motor to around 7k and to break the 400hp mark. any suggestions at all? thanks guys
#5
in the process of building a 347. ported victor jrs with the 2.05 intake valves, custom cam from jay allen, 36lb injectors the all deal. im just pulling my hair out over what intake to buy. i really like the victor 5.0 intake or the trick flow r series. i seen those spyder intake manifolds but then seem like too much money and hassle. i also dont want any intake to be crossing the overkill line. looking to spin the motor to around 7k and to break the 400hp mark. any suggestions at all? thanks guys
#8
A chip will raise the rev limiter. My SCT did anyhow. Raised it to 7000. I have yet to get an MSD box and would have that set lower because I don't like the fact they cut fuel to limit RPM.
I have an extrude honed GT 40 (huge runners) topped with a Comp Cams Polymer Powerbox upper.
I have an extrude honed GT 40 (huge runners) topped with a Comp Cams Polymer Powerbox upper.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM