OK i $%&#*@ up my t5 rebuild lol
12-30-2008, 10:58 PM
#1
1st Gear Member
Thread Starter
Join Date: Jan 2008
Posts: 86
OK i $%&#*@ up my t5 rebuild lol
I must have done something wrong, i can not an i mean can not get my roll pin to line up for the shifter, i must be getting something lined up wrong with the shift forks. Any ideas?
12-30-2008, 11:43 PM
#3
in limbo
Join Date: Jan 2007
Location: Iowa
Posts: 7,300
LOLOLOLOLOL!!!!!
i did the same thing! you really just need to mess with it in order to get it right but you need to make sure that sleeve on the shaft fits inside of the clip between the two forks. the first picture looks almost right except the first fork isnt in the right place. you'll honestly just have to mess with it until it all works properly. i wish i had a picture for you. i didnt think to take a picture of my shift forks when i rebuilt mine. sorry
i did the same thing! you really just need to mess with it in order to get it right but you need to make sure that sleeve on the shaft fits inside of the clip between the two forks. the first picture looks almost right except the first fork isnt in the right place. you'll honestly just have to mess with it until it all works properly. i wish i had a picture for you. i didnt think to take a picture of my shift forks when i rebuilt mine. sorry
