JBA headers and JBA exhaust - comments?
#1
JBA headers and JBA exhaust - comments?
So here is what I ordered last evening:
JBA midlength coated headers
JBA H-pipe with bungs welded in
JBA 2.5" exhaust
From what I have read, the JBA exhaust is quiter than Flowmaster 40's but louder than Magnaflows. I am hoping for the best of both worlds.
This is going in the '66 Coupe with '93 5.0 EFI and AOD with stock mounts, etc.
Anyone have any experience with the JBA exhaust first hand? Like it or hate it?
JBA midlength coated headers
JBA H-pipe with bungs welded in
JBA 2.5" exhaust
From what I have read, the JBA exhaust is quiter than Flowmaster 40's but louder than Magnaflows. I am hoping for the best of both worlds.
This is going in the '66 Coupe with '93 5.0 EFI and AOD with stock mounts, etc.
Anyone have any experience with the JBA exhaust first hand? Like it or hate it?
#2
i have a set of jba headers on my 07 f150. they are a quality piece my only complaint is that on the passenger side due to lack of space, the rear cylinder primary runs at a 90* angle directly into the side of the collector. they made the truck sound better but because my truck is my daily driver i have a quiet exhaust on it so under load i can hear the exhaust firing into the headers. maybe if the headers were thicker or my exhaust was louder i wouldnt hear it.
long story short, jba makes a great product but its way over priced. new, the headers for my truck are $800 but got them off ebay new for $160
long story short, jba makes a great product but its way over priced. new, the headers for my truck are $800 but got them off ebay new for $160
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM
trashxtrash
4.6L (1996-2004 Modular) Mustang
4
09-20-2015 10:49 PM
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM