5.0L (1979-1995) Mustang Technical discussions on 5.0 Liter Mustangs within. This does not include the 5.0 from the 2011 Mustang GT. That information is in the 2005-1011 section.

runs fine then won't, stomp gas to start again?

Thread Tools
 
Search this Thread
 
Old 10-03-2009, 11:40 AM
  #1  
chickenbutt
1st Gear Member
Thread Starter
 
chickenbutt's Avatar
 
Join Date: Mar 2008
Location: South Carolina
Posts: 99
Arrow runs fine then won't, stomp gas to start again?

So the car runs fine cold but when i start to go down the street and it warms up it likes to cut off and then sometimes I have to floor the gas to get it started.. Keep in mind this is fuel injected... vortech supercharger headers injectors etc and when i put coolant in it I doesn't seem to ever fill up and i mean i put like four or five GALLONS of water in it.. I watch the water lower in the radiator after i stop pooring it. Looked at the dip stick and didn't see any water. don't know wat do do really??
Attached Thumbnails runs fine then won't, stomp gas to start again?-3n73k13p85o55p95sa99ud1be2b4107cb1a0e.jpeg  
chickenbutt is offline  
Old 10-03-2009, 07:22 PM
  #2  
Jordan's5.0
1st Gear Member
 
Jordan's5.0's Avatar
 
Join Date: Sep 2009
Location: Alabama
Posts: 102
Default

check your oil for water sounds like a popped head gasket to me
Jordan's5.0 is offline  
Old 10-03-2009, 09:35 PM
  #3  
chickenbutt
1st Gear Member
Thread Starter
 
chickenbutt's Avatar
 
Join Date: Mar 2008
Location: South Carolina
Posts: 99
Default

I have but didn't see any?
chickenbutt is offline  
Old 10-03-2009, 09:36 PM
  #4  
chickenbutt
1st Gear Member
Thread Starter
 
chickenbutt's Avatar
 
Join Date: Mar 2008
Location: South Carolina
Posts: 99
Default

and these heads have been on here for no more than 2000 miles... is it normal to just go out like this?? it did sit for about two years or so too but still.. would that effect it?
chickenbutt is offline  
Old 10-03-2009, 09:50 PM
  #5  
92GTKID
 
92GTKID's Avatar
 
Join Date: Oct 2009
Location: Mass
Posts: 6
Default

try doing plugs wires and a new cap and rotor make sure you do the cap and rotor at the same time the same kinda **** happened to me you muight ot need new plugs but its still good to change them
92GTKID is offline  
Old 10-03-2009, 10:13 PM
  #6  
Jordan's5.0
1st Gear Member
 
Jordan's5.0's Avatar
 
Join Date: Sep 2009
Location: Alabama
Posts: 102
Default

plugs and wires arent gonna make you loose 5 gallons of coolant i dont care how bad they are and thats something im not sure about i will leave that question to the people with a little more expirience
Jordan's5.0 is offline  
Old 10-03-2009, 10:24 PM
  #7  
a_penquin
4th Gear Member
 
a_penquin's Avatar
 
Join Date: Jul 2009
Location: GA
Posts: 1,022
Default

Well the coolant has to go somewhere, the only places it could go is:

Oil- cracked head gasket, cracked cylinder
Cylinder- cracked head, cracked head gasket, cracked cylinder
floor boards- blown heater core
ground- blown radiator, cracked hose, bad water pump, cracked block/head.

Dose it smoke? Any signs of water in the exhaust? Is the passenger floorboard wet? Giant puddle of water on the ground? Milky discolored oil? Signs of coolant in the engine bay?
a_penquin is offline  
Old 10-04-2009, 01:04 AM
  #8  
chickenbutt
1st Gear Member
Thread Starter
 
chickenbutt's Avatar
 
Join Date: Mar 2008
Location: South Carolina
Posts: 99
Default

Originally Posted by a_penquin
Well the coolant has to go somewhere, the only places it could go is:

Oil- cracked head gasket, cracked cylinder
Cylinder- cracked head, cracked head gasket, cracked cylinder
floor boards- blown heater core
ground- blown radiator, cracked hose, bad water pump, cracked block/head.

Dose it smoke? Any signs of water in the exhaust? Is the passenger floorboard wet? Giant puddle of water on the ground? Milky discolored oil? Signs of coolant in the engine bay?
no to everything.. im baffled myself.. guess i will take the heads off cuz like you said the coolant is going somewhere...
chickenbutt is offline  
Old 10-04-2009, 12:55 PM
  #9  
Jordan's5.0
1st Gear Member
 
Jordan's5.0's Avatar
 
Join Date: Sep 2009
Location: Alabama
Posts: 102
Default

It can't just dissapear and if he doesnt have any water coming out the exhaust or milky oil it isnt a headgasket. Unless its your heater core but it shouldnt quit and not want to crank because they all point to head gasket except no sign of coolant going anywhere honestly im lost sorry man no clue
Jordan's5.0 is offline  
Old 10-04-2009, 07:53 PM
  #10  
chickenbutt
1st Gear Member
Thread Starter
 
chickenbutt's Avatar
 
Join Date: Mar 2008
Location: South Carolina
Posts: 99
Default

Its okay, I already got the upper intake off but I can't get the stupid fuel lines off!!! I have that little tool or w/e I think but I guess im not using int right??! Any ideas? Im trying to take the lower intake off ant take the heads off.
chickenbutt is offline  


Quick Reply: runs fine then won't, stomp gas to start again?



All times are GMT -5. The time now is 08:19 AM.