5.0L (1979-1995) Mustang Technical discussions on 5.0 Liter Mustangs within. This does not include the 5.0 from the 2011 Mustang GT. That information is in the 2005-1011 section.

running lean and pinging...help

Thread Tools
 
Search this Thread
 
Old 10-22-2009, 05:58 AM
  #1  
9165pt0
3rd Gear Member
Thread Starter
 
9165pt0's Avatar
 
Join Date: Dec 2006
Posts: 569
Default running lean and pinging...help

hey guys, i have been trying to fig out why my car is pinging. timing can be 10-16 degress and it will still ping the same, and usually under the same conditions. which are a lil bit under normal driving while accelerating, or while giving half throttle in overdrive at highway speeds. i ran seamfoam and it didnt help. i ran codes, and the egr came up bad, so i replaced it. its been tuned up about 8000 miles ago. its a stock hatch 1988, only mods are o/r h pipe, and cai. i did pull a spark plug and it was chalk white, so its running lean as well.
how do i make this go away?
9165pt0 is offline  
Old 10-22-2009, 06:42 PM
  #2  
9165pt0
3rd Gear Member
Thread Starter
 
9165pt0's Avatar
 
Join Date: Dec 2006
Posts: 569
Default

help?
9165pt0 is offline  
Old 10-22-2009, 09:10 PM
  #3  
mjr46
D.R. THE PATHETIC DORK
 
mjr46's Avatar
 
Join Date: Jun 2007
Location: West Virginia
Posts: 30,863
Default

check fuel pressure, but I'd run a koer and make sure there are no codes, if no codes, then make sure the balance has not spun and is giving you an inaccurate timing reading, also make sure car is not running hot period
mjr46 is offline  
Old 10-23-2009, 12:44 AM
  #4  
nacanitihs
5th Gear Member
 
nacanitihs's Avatar
 
Join Date: Mar 2006
Location: Massachusetts, New Bedford
Posts: 3,035
Default

ya check ur fuel pressure. should be around 40or 45psi (dont remember exactly) with the vac line off the fpr. if is bad ur fuel pump or fuel pressure regulator may be going bad.

ur setting the timing with the spout connector our right? and what fuel are you running?
nacanitihs is offline  
Old 11-10-2009, 05:58 PM
  #5  
9165pt0
3rd Gear Member
Thread Starter
 
9165pt0's Avatar
 
Join Date: Dec 2006
Posts: 569
Default

havent had a chance 2 work on it in a while. but heres an update. the balancer is good, i put some 91 octane in it. it still pings. usually only around certain low rpms while accelerating or while in od and 3/4 throttle. i even bumped the timing down to 8 degrees and its the same thing. i will try to get a fp tester to check it, any other ideas
9165pt0 is offline  
Old 11-10-2009, 07:08 PM
  #6  
fordboy5.0
1st Gear Member
 
fordboy5.0's Avatar
 
Join Date: Oct 2009
Location: colorado
Posts: 140
Default

Originally Posted by 9165pt0
havent had a chance 2 work on it in a while. but heres an update. the balancer is good, i put some 91 octane in it. it still pings. usually only around certain low rpms while accelerating or while in od and 3/4 throttle. i even bumped the timing down to 8 degrees and its the same thing. i will try to get a fp tester to check it, any other ideas
hmmm... sounds like a loose rocker arm or somethin check your valve terain by putting a long screw driver up to the valve cover and you can usually tell which side and wich location the loose rocker arm is or you might have a bad lifter or lifters, running lean like that for long periods of time can crack piston rings also. oh and your timing should be between 16-20 degrees.

Last edited by fordboy5.0; 11-10-2009 at 07:10 PM.
fordboy5.0 is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jb145700
4.6L V8 Technical Discussions
9
08-21-2022 06:37 AM
JimC
Street/Strip
15
10-07-2015 07:02 PM
heslekrants
Street/Strip
11
09-23-2015 04:02 PM
TorinoCobra070
SVT Forums
8
09-18-2015 10:34 AM
uedlose
Archive - Parts For Sale
0
09-10-2015 03:30 PM



Quick Reply: running lean and pinging...help



All times are GMT -5. The time now is 10:11 AM.