1983 5.0 With tranny problem
Pulled tranny out of mustang 5.0 bc of leak [automatic]My son replaced rear seal....In his infinite wisdom he left converter bolted to flex plate. Put tranny back in an started leaking not long after again. Converter should be slid into tranny then assembled, yes ? Guy he bought it from replaced tranny that WAS in it and put a 1965, there about, tranny in it, he took the 1 that was in it and put in his older stang......Found out after
sale....could this be the problem, even though they bolt up. thanks |
There's no reason that the converter "has" to be installed on the tranny 1st, other than it makes it a lot easier to install. Leaving it on the flexplate usually makes it a b_itch to seat the converter fully. If the tranny is working properly, it's not the source of your leak.
|
Originally Posted by FLcracker9
(Post 6722900)
There's no reason that the converter "has" to be installed on the tranny 1st, other than it makes it a lot easier to install. Leaving it on the flexplate usually makes it a b_itch to seat the converter fully. If the tranny is working properly, it's not the source of your leak.
|
All times are GMT -5. The time now is 03:14 PM. |
© 2024 MH Sub I, LLC dba Internet Brands