cobrakiller306

hey guys quick question, i'm throwing sum heads on my buddys car for him, starting to set the lash, when i go for 0 lash, the lifters start to compress quite a bit just by tighting the poly lock by finger, its not that i'm turing hard at all. is it that his lifters are just bled off and he didn't soak them good enough? not 100% sure if they need to be resoaked or not. any tips??

AdderMk2

dont ned to re-soak them. just prime the oil pump while turning the motor over.

and you tighten the poly locks until you cant wiggle the pushrod anymore... dont be hercules

Bubba 95SN

Remove distributor, spin oil pump shaft pump up lifters.

cobrakiller306

its quite a ways out from crankin it over with the key yet, opted to prime the pump again through the distributer gear. took a while, but seems to be getting better. i wasn't sure if i was gona be able to do that but i got the tools so its goin good, thanx guys.