chilywily72

I have a 93 mustang gt with a bbk inner fender cold air kit, cobra upper and lower, msd cap rotor coil and 8mm plug wires bbk equal length header x pipe and borla mufflers. I have stock maf and stock throttle body. On craiglist there a guy selling a 80mm cobra mass air flow setup that says its calibrated for 26lb injectors which come with it for $100 would that be a good setup for my car and what sze throttle body would work with that setup for my car? any input is suggested hes also selling a 70mm maf setup with 19lb injectors

aode08

No need to change anything, it will work just fine with what you have.


The 5.0 Cobra used the bigger MAF and 24 lb injectors,again with only 235 HP overkill

nitrous_bob

all stock induction will support about 300 hp.

your fine where u are.

AdderMk2

link to the maf and injectors? you likely wont be able to use them without a tune