Zoom777

Hey guys im fairly new to this and could use your help. As i was changing my waterpump the other day i noticed that one of my vacuum lines was cracked and needed to be replaced. But when i went to follow the line to where it was leading to it wasnt even attached to anything. I took a pic of it. But for some reason i cant figure out how to post in on this thread. Anyways i'll try and describe it to you. Its a vacuum line running from the upper intake to ?. The line is right above the cap and rotor if that helps.

Zoom777

Oh it would probably help if you knew what kind of motor it was. Its a 95 mustang GT with the 302 and aftermarket GT40 Upper and lower intake

Venomantidote95

A pic would help but i don't recall ever seeing that!

FORD TOUGH

To post a picture click manage attachment then browse, select the picture you want then upload.

Does your car still have the vacuum hose routing on it? You may have to trace the hoses back to the motor till you find the one unhooked.What color was the hose?
http://www.mustang-tech.org/wiki/Ima..._Schematic.jpg

Zoom777

Its a black hose and it does have the hose still on the part of the upper intake. The other end of the hose is just hanging freely. Also im not seeing this manage attachment. Is it because i only have a couple posts that it wont allow me to post any pics????

Zoom777

ok so i kinda figured it out with the whole picture situation. If you click on my profile name and look under my picture albums it will be under the album named vacuum hoses. Thanks for the help guys.

MK7JUNKIE

Might have been an extra hose left over from the explorer that the intake came off from. I know when I did the swap the explorer intake had quite a few extra vacuum lines. Might be more underneath.

Joel5.0

Sounds like the vacuum hose for the CANP (CANister Purge) solenoid.

Bubba 95SN

Canister purge hooked up? If not it may be the right side high speed rendezicator hose.

buster

I can name that part in 3 sentences..........