4.6l to a 5.0 swap
I'm not quite sure if this question is for the 79-95 or 96-up section but here it goes I currently have a rod knock in my 96 GT and I want to know if I put a 5.0 in what all am I going to have to change since the 95 and 96 are the same as far as body goes I know the obvious the computer will have to come with the 5.0 will the motor mounts work will the tranny and such need to be switched? Just looking for a nice list as a starting point. Thanks for any help.
|
my guess would be mounts, bellhousing to tranny starter o2 sensors exhaust you would probably need the whole engine out of a 94-95 with all the accessory. if i were you i would just rebuild yours it will be cheaper and easier
|
K-member, accessories, wiring, exhaust, transmission
just buy another 4.6l |
Its just that its so much cheaper to rebuild a 5.0 and very easy to find parts and cheap to replace them
|
Originally Posted by Fillup87
(Post 7481596)
Its just that its so much cheaper to rebuild a 5.0 and very easy to find parts and cheap to replace them
will put you around 11:1 and pull hard to 7000. obviously go with longtubes and a good midpipe/catback and some 4.10's |
All times are GMT -5. The time now is 03:47 PM. |
© 2024 MH Sub I, LLC dba Internet Brands