TreCool626

I recently purchased a Pro-5.0 shifter and installed it myself. I don't get to drive my car much because I'm away at school, but I was home over Thanksgiving and I powershifted 2nd and then hit 3rd and then the shifter was loose in my hand. Anyone else have this problem? I'm hoping it is just because I didn't tighten the bolts enough. Any suggestions to prevent it from happening again would be helpful. Thanks in advance.

gt200mph

just make sure you tighten it.......dont overtighten the base though it dont take that much to strip it.

95Stealth302

I just put mine in and its just fine, make sure the **** is good and tight, the bolts to the tranny are tight, and the stop bolts are in the correct place.

Pitviper100

how much is a pro 5.0 shifter and where can i get one?

vfast

try putting some loc-tight on the bolts use the red so you can loose them when you need to

eighty7five0

how much is a pro 5.0 shifter and where can i get one?</P>


they go for about $150 give or take and im not really an ohio person so i dont know where you can get one locally. just order one in a catalog</P>

TreCool626

They are about $190 and you can get them all over the place. I don't remember where I ordered mine from. It might have been summit or jegs. not sure.

Buzzstang

<FONT face="Times New Roman, Times, serif" size=6>I HAVE ONE FOR SALE.</FONT></P>

Shaggy92Lx

hurst shorty shifter $50 from the guy who did my transmission. short and precise. South Side machine also has shorter sticks and cheap under $75

Buzzstang

Does anybody want this shifter. <FONT size=6>Pro 5.0</FONT></P>