When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
5.0L (1979-1995) MustangTechnical discussions on 5.0 Liter Mustangs within. This does not include the 5.0 from the 2011 Mustang GT. That information is in the 2005-1011 section.
Hey guys. I had a couple questions about hooking up a mech. oil pressure gauge. So does the actual pressure line tap into the oil pan? Also I've been thinkin of a good place to hook my power wire into. Any segestions? Thanks.
ok to start your oil pressure line has to be on the pressure side, if you drill your pan and put it in their it prolly would not read anything, Here is what you do, where the stock oil pressure sending unit is take that out, go to the hardware store and get a brass t fitting that is 3/8 pipe thred its going to have 3 female ends, then get an adaptor its just a small pice of 3/8 pipe with threds, screw that in one side of the t, then put the stock oil pressure sending unit back in another hole, and then put the new line in the last hole simple as that.