Duncan_GT

Measuring my mains again. Is it ok to put plastigauge on all the caps and torque them down simultaneously instead of measuring one at a time?

tinman

I always use a micrometer to make sure themains and the bearings are both inthe ballpark. Then I'll use the plasti-gage on only one bearing at a time
There's no reason to want to hurry this job at all.
I WILL NOT allow any other persons in my work area while I'm doing stuff like this as I don't need any distractions.........
Even from nude 18 year old females, LOL.....

reldla1996

I've always done it one bearing at a time, but no reason why you couldn't do all the mains at once. Now the rods, those would be tough to do at the same time! Hope you're smiling!

Duncan_GT

Ha, well yeah that makes sense. I'll end up doing one at a time. I started getting tired last night so laziness came with it. Figured I'd stop before I did something stupid.

Thanks for the suggestions.