Performance Motor Build PTV???
#1
Performance Motor Build PTV???
I am building a 5.0 I am looking for some minor upgrades to add more horsepower for the build and was wondering if anyone knows info on piston to valve clearance with my current setup
What I have below is the current performance stuff i plan on using and am looking for info of what other internal motor parts i can add for more HP roller rocker arms etc??? also anyone point me in the right direction for new springs and hardened pushrods for this as i think i may need them?
Also, what do you guys think about the stock gt40p heads? what could i do to upgrade them for better performance bigger valves?
4 barrel high rise intake
block is a 5.0 ho
heads are stock gt40p heads
camshaft is lift .528/.533
dome pistons L2249N
Really questioning PTV clearance with the heads camshaft and the pistons... Any advice is greatly appreciated.
What I have below is the current performance stuff i plan on using and am looking for info of what other internal motor parts i can add for more HP roller rocker arms etc??? also anyone point me in the right direction for new springs and hardened pushrods for this as i think i may need them?
Also, what do you guys think about the stock gt40p heads? what could i do to upgrade them for better performance bigger valves?
4 barrel high rise intake
block is a 5.0 ho
heads are stock gt40p heads
camshaft is lift .528/.533
dome pistons L2249N
Really questioning PTV clearance with the heads camshaft and the pistons... Any advice is greatly appreciated.
#2
You are going to have to measure this for yourself to have any good answer at all.
I'd use the clay method so just do a search or google it up.
I always like .100 PTV clearance but on my current set-up I have about .080 which I can live with as it an SRC with lots of valve spring pressure......
I'd use the clay method so just do a search or google it up.
I always like .100 PTV clearance but on my current set-up I have about .080 which I can live with as it an SRC with lots of valve spring pressure......
Thread
Thread Starter
Forum
Replies
Last Post
M3hunter
S197 Handling Section
0
09-05-2015 03:42 PM