Excessive RPMs
 

1...1995 GT, 5 speed, Edelbrock heads and 65mm intake, few other minor mods. RPM's at 1600 until car comes to a COMPLETE stop....then returns to ~900. I guess that the PCM is involved....any quick fixes...suggestions...?

2...Also, is there any special trans fluid to use.....or just any quality Mercron/MercronII...?

3...Best place to buy original pedal 'rubbers'.....no Ford dealer in town.

Thanx for any info.

Mercon V is Synthetic, what I use in mine.

Mercon and II, Dexron III (there was no Mercon III) are very old and are supposedly not available anymore.
I have seen IV at Walmart, but not Motorcraft. Mercon V has superseded all other Mercon, and is what it
should say in the user manual. About 4-5 quarts for a pan drop and filter change. Can use any Mercon V
on the walmart shelf...

Check eBay for pedal rubbers, or covers...

Mercon V...? Man....where've I been all these years. My trans is a 5-speed manual...I guess it also uses the same fluid as the automatic...?
Thanx for the info, 08mustangDude.

Yes, even my former '06 HHR 5-Speed took ATF, I used Dexron VI in that, it's
what it called for.

TSB 06-26-1
MERCON ATF IS BEING REPLACED BY MERCON V AS A SERVICE FLUID FOR SOME MANUAL TRANSMISSIONS
1985-2007 Mustang

Thanx 3.0....appreciated.