New Notch
#1
New Notch
1986 mustang
1990 front end
306, T-5
weld wheels
bored 30 over
crane scorpion roller rockers
msd 6al
msd wires
E303 cam
heads done 202 160
mac headers
horse power pulleys
750 cfm edelbrock carb
wiend intake
arp studs and bolt kit
high flow oil pump
work done after photos to pass safety:
- rust fixed and undercoated
- body trim painted and put on
- paint chips painted
- new gas tank
- new rad and hoses
- heater hoses
- windshield wiper system
- door panels
- new horn
- new e-brake
- new windshield
- frame ties (not yet but in next few days)
- then to the drags.
A friend and I bought the car for street and strip purposes. We are 18 years old and are learning lots. It's a good project car for us. We bought it for $3000. The guy we bought it off of said it would run low 12's.. yet somehow I doubt it. Any guesses?
1990 front end
306, T-5
weld wheels
bored 30 over
crane scorpion roller rockers
msd 6al
msd wires
E303 cam
heads done 202 160
mac headers
horse power pulleys
750 cfm edelbrock carb
wiend intake
arp studs and bolt kit
high flow oil pump
work done after photos to pass safety:
- rust fixed and undercoated
- body trim painted and put on
- paint chips painted
- new gas tank
- new rad and hoses
- heater hoses
- windshield wiper system
- door panels
- new horn
- new e-brake
- new windshield
- frame ties (not yet but in next few days)
- then to the drags.
A friend and I bought the car for street and strip purposes. We are 18 years old and are learning lots. It's a good project car for us. We bought it for $3000. The guy we bought it off of said it would run low 12's.. yet somehow I doubt it. Any guesses?
#3
id say low 14s. its not a bad start though. Looks like a nice car to tear up at the track. Good luck man!
edit: woulda liked too see another 4 eye, but whats done is done.
edit: woulda liked too see another 4 eye, but whats done is done.
Last edited by CBurn; 07-08-2009 at 05:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
SteelerNation82
V6 (1994-2004) Mustangs
11
09-09-2015 09:06 AM