How to distinguish different Flowmaster series???
#11
RE: How to distinguish different Flowmaster series???
K, so pics were a no go. It was too dark. For some reason the rust was not as bad as I thought. the casings are almost rust free. Just the welding is rusted. I searched the part number (42443), and it turns out these...
http://www.flowmastermufflers.com/pr...oducts_id=3287
They are 2 1/4 piping. The rest of my piping is 2.5". Is this going to choke me at all?
http://www.flowmastermufflers.com/pr...oducts_id=3287
They are 2 1/4 piping. The rest of my piping is 2.5". Is this going to choke me at all?
#12
RE: How to distinguish different Flowmaster series???
I THINK on my delta flows you could see where they welded in the V's inside the muffler but I honestly can't remember. I would have gotten 2.5" mufflers though.
#13
RE: How to distinguish different Flowmaster series???
ORIGINAL: Rajun_Cajun
K, so pics were a no go. It was too dark. For some reason the rust was not as bad as I thought. the casings are almost rust free. Just the welding is rusted. I searched the part number (42443), and it turns out these...
http://www.flowmastermufflers.com/pr...oducts_id=3287
They are 2 1/4 piping. The rest of my piping is 2.5". Is this going to choke me at all?
K, so pics were a no go. It was too dark. For some reason the rust was not as bad as I thought. the casings are almost rust free. Just the welding is rusted. I searched the part number (42443), and it turns out these...
http://www.flowmastermufflers.com/pr...oducts_id=3287
They are 2 1/4 piping. The rest of my piping is 2.5". Is this going to choke me at all?
Thread
Thread Starter
Forum
Replies
Last Post
MustangForums Editor
Mustang News, Concepts, Rumors & Discussion
0
09-18-2015 12:25 PM