{update}FINALLY some good news 1991 notchback gets worked!
{updated new post content below}
Long wait but finished welding up the replacement car now I just have to replace complete powertrain, swap compete interior, upgrade all electrics, front end will get all re-done with 2" drop spindles, a host of MM parts braking system will be upgraded similar to 1993 cobra type correct offset rear 2000 watt stereo system... and figure out the 11' hydraulic clutch system I am putting together <<whew>> http://www.thatmetalbox.com/Automoti...ngWeldComplete http://www.thatmetalbox.com/Automoti..._Coupe_1_t.jpg http://www.thatmetalbox.com/Automoti..._Coupe_2_t.jpg {older post below} Got some good work done on my car, finally after loosing my 2 coupes and getting seriously hurt :-P Im crawling up from the dark pit, my fingernails broken and shattered, but Ill be damned if Im not going to keep trying, read; http://www.thatmetalbox.com/automoti...angBlanchWeld/ http://www.thatmetalbox.com/automoti...eWeld100_t.jpg |
RE: FINALLY some good news 1991 notchback gets worked!
good work
|
RE: FINALLY some good news 1991 notchback gets worked!
nice weld job
|
RE: FINALLY some good news 1991 notchback gets worked!
part 2 this weekend:D
then have to wait for $$ to continue the build - hopefully the insurance company will finally pay for my totaled car, its been 4 months already and they still are inspecting it [>:] |
RE: FINALLY some good news 1991 notchback gets worked!
welds look nice
|
RE: FINALLY some good news 1991 notchback gets worked!
nice
|
RE: FINALLY some good news 1991 notchback gets worked!
Wow, that welder has some real talent. I looks real nice, I hope you have some better luck with this one.
|
RE: FINALLY some good news 1991 notchback gets worked!
Nice welding.
Are you the same guy that had his notch totalled on the freeway on-ramp a whiloe back? |
RE: FINALLY some good news 1991 notchback gets worked!
[:'(]phppppppppppppppppppppppppppt!!![:'(]
[:@]yup thats me[:@] http://www.thatmetalbox.com/automoti...DSCF3780_t.jpg http://www.thatmetalbox.com/automotive/1991crashed/ might not look like too much but [ul][*]whole quarter panel wavy like the ocean[*]both floorpans buckeled up, (even though subframe connectors!)[*]Seat studs ripped out of floorpans[*]Floor of trunk warped[*]exhaust hangers ripped out of "frame" and exh itself bent up[*]roll-over fuel shut off switch was activated[*]got knocked out briefly - from REAR end collision![*]Got 2 slipped discs in spine from incident, one 6mm sticking out the side.....[/ul] |
RE: FINALLY some good news 1991 notchback gets worked!
NIce job. Welds look very good.
|
All times are GMT -5. The time now is 10:33 PM. |
© 2024 MH Sub I, LLC dba Internet Brands