kweb288

This guy is like 20min away from my house, and i was thinking about buying/looking at these TFR heads he had for sale. Can you guys tell me anything about them since he is a little undescriptive about it, i sent him a message but i wanted to see what you guys thought. http://cgi.ebay.com/ebaymotors/MUSTA...QQcmdZViewItem


I am planning on a holley systemax intake and a anderson N-51 cam.. so im probably going to have to notch the psitons. Would they work with a stock short block?

rmodel65

you'll need your block set up for orings

kweb288

what would you have to do for this? do not really know to much about orings and all that jazz?

lxman1

An o-ring groove must be machined in the block around each cylinder.

WhiteWindsor

You do not have to machine yourblock to use o-ringed heads.

bikeboy587

you do not need to o-ring ur block. my eddys have orings in them and i did nothing to my block, u just need the special gasket

woodsy

Just mill the head to eliminate the receiver groove, its .010-.015 deep, no big deal

immr.mustang

+1 for milling them and getting your compression up!!