Hamutoff

{updated new post content below}
Long wait but finished welding up the replacement car
now I just have to replace complete powertrain, swap compete interior,
upgrade all electrics, front end will get all re-done with 2" drop spindles, a host of MM parts
braking system will be upgraded similar to 1993 cobra type correct offset rear
2000 watt stereo system... and figure out the 11' hydraulic clutch system I am putting together
<<whew>>
http://www.thatmetalbox.com/Automoti...ngWeldComplete


{older post below}
Got some good work done on my car, finally after loosing my 2 coupes and getting seriously hurt :-P
Im crawling up from the dark pit, my fingernails broken and shattered, but Ill be damned if Im not going to keep trying, read;

http://www.thatmetalbox.com/automoti...angBlanchWeld/

primetime5.0

good work

stang8689

nice weld job

Hamutoff

part 2 this weekend

then have to wait for $$ to continue the build - hopefully the insurance company will finally pay for my totaled car, its been 4 months already and they still are inspecting it [>:]

bighungrymatt

welds look nice

QatarStang

nice

ryan_89_mustang

Wow, that welder has some real talent. I looks real nice, I hope you have some better luck with this one.

RODRIGUEZ

Nice welding.

Are you the same guy that had his notch totalled on the freeway on-ramp a whiloe back?

Hamutoff

[:'(]phppppppppppppppppppppppppppt!!![:'(]

[:@]yup thats me[:@]


http://www.thatmetalbox.com/automotive/1991crashed/

might not look like too much but [ul][*]whole quarter panel wavy like the ocean[*]both floorpans buckeled up, (even though subframe connectors!)[*]Seat studs ripped out of floorpans[*]Floor of trunk warped[*]exhaust hangers ripped out of "frame" and exh itself bent up[*]roll-over fuel shut off switch was activated[*]got knocked out briefly - from REAR end collision![*]Got 2 slipped discs in spine from incident, one 6mm sticking out the side.....[/ul]

98MustangGT46

NIce job. Welds look very good.