Nitrous Dyno numbers are in!
07-19-2008, 12:54 PM
#16
D.R. THE PATHETIC DORK
Join Date: Jun 2007
Location: West Virginia
Posts: 30,863
RE: Doing to the Dyno tomorrow for nitrous tune!
ORIGINAL: bikeboy587
Well I got a stud girdle on the bottom end, head studs, Ross Forged Aluminum pistons that are suppose to be good up to a 200 shot so they say, 190lph fuel pump and 24# injectors so I don't think blowing up will be a problem[/align][/align]Then again my car is named Murphy's Law haha[/align][/align]I'm only worried about the t-5 while sprayin the juice[/align]
Well I got a stud girdle on the bottom end, head studs, Ross Forged Aluminum pistons that are suppose to be good up to a 200 shot so they say, 190lph fuel pump and 24# injectors so I don't think blowing up will be a problem[/align][/align]Then again my car is named Murphy's Law haha[/align][/align]I'm only worried about the t-5 while sprayin the juice[/align]
07-19-2008, 07:07 PM
#17
4th Gear Member
Thread Starter
Join Date: Mar 2007
Location: Buffalo, NY
Posts: 1,541
RE: Doing to the Dyno tomorrow for nitrous tune!
Only got a crappy cell phone pic for now. Will get a better pic later. Graph goes from 3000rpms to 5400 rpms, the numbers are:
Max HP 374.4
Max TQ 504.3
Avg hp 353
Avg tq 437
Avg A/F 10.9
Blue line-tq
Red line-hp
Black line-A/F
07-20-2008, 01:58 AM
#20
4th Gear Member
Thread Starter
Join Date: Mar 2007
Location: Buffalo, NY
Posts: 1,541
RE: Doing to the Dyno tomorrow for nitrous tune!
jetted for a 125 shot according to zex jetting as it says in the sig. only way to lean it out some would be to up the nitrous jet but the bottle was only at about 700 psi bec i did not have my warmer hooked up yet so there is more left in the car as it when i put the heater on it