kremer306

I justs got 24 lb injectors and my car acts like its choked up. my 19 lb injectors were maxed out with the fuel pressure set at 55-60. I lowered the fuel pressure for the 24s but didnt help the mass air is a 80 mm and its engraved that its calibrated for 24s. WHAT CAN i DO FOR THIS PROBLEM.

NoGo95GT

It's hard to help without knowing your mods.

kremer306

306 BLOCK alm heads trick flow upper lower intake trick flow stage 2 cam timing 15 advanced bbk fuel pressure regulator

kremer306

forgot bbk 70 mm throttle body

kremer306

would my computer have something to do with it

primetime5.0

define choked up

Hamutoff

were the injectors new or used? was the mass air flow sensor/unit new or used if either were used do you know for sure if they are good? for example did you witness the car they were on running well?

was your car running quite well before the modifications, if so are your only mods since that time the parts mentioned and then reducing the fuel pressure?

finally what part numbers are the injectors and mass air flow sensor/unit and your computer

mattdel

why is the pressure so high?

mjr46

with the little you mentioned it doesn't seem that it'd have the injector duty cycle maxed , a typical h/c/i can support 19's without upgrading to 24's....you seem to have another issue that is causing your prob..define issue more please and when it all started

kremer306

yes the injectors are used and the mass is ued it idles fine but it revs slower and it doesnt seem to have as much power throughtout all rpms it doesnt miss out like any of the parts are bad also i ohmed the injectors befor insall they check out good and if the mass was bad it would idle like crap and when it reved it would rev worse than it is right not sure bout that let me go check what computer i have