Explosive

Car doesn't look that rough.


As for price, I'm amazed at the price of SBC stuff. I'm rebuilding a Chevy 350 in autos. And got a cam and lifter set for under $40. And it will have some lope, it's not a oem replacement. The parts are damn near free.

jtmustang

^^^ yep chebby stuff is always a lot cheaper than ford and dodge...


and to the op i would also look into maximum motorsports they have some very good quality suspension stuff

H0SS302

Todays progress was...MESSY. i took out all the rest of the panels, back deck, took off the trunk lid(getting a new one) pas side door panel wen by by, and lastly the headliner and all trim. I also started picking at the sound deadener(the grey spots), but it is TUFF to get off. any tips tricks would be welcome.

the only thing left is the dash( i need to learn how to take it out) so i can take out the heater core and all radio wiring.

pics from today.

gil4x4

Interior is shot but the exterior doesn't look to bad. I see we have the same driver door panel.

H0SS302

how do u figure the interior is "shot" there is not 1 crack in the dash, the headliner was in good shape.. all i would need to do is get new seats and put carpet in it.. the door panels werent even that bad.

but the idea with this car is lightweight...

H0SS302

Does anyone know what wires i can and cant yank? the only wires that i need to keep are the lights correct? everything else is just some kinda sensor right?

glaranotch

wow this is tight i hope you keep it up, were do i subscribe?

H0SS302

Also, can i take that brace looking thing out of the back seat area? im also going to cut the extra metal out of the door panel area(replacing with aluminum panels.

H0SS302

screw sound deadener... PITA to get off! Drivers side is ALMOST off, ill finish tomorrow for sure. clipped a few un needed wires today also.

H0SS302

does anyone have an easy write up on dash removal so i can get the heater core out?