LX tail light swap ?
#1
LX tail light swap ?
What's up everyone,
I'm obviously new to the forum, which explains why put my full name as the screen name instead of something a little more edgy. Duh!
Anyways, I just put some LX lenses on my GT, and I had a quick question. I used the new hardware provided in the box, but the center of the light bows out approximately 1/8". There is some minor flex when pressure is applied to the center of the light. I just want to know if this is an issue, or a common occurrence. I'm not quite sure if the clips seated properly or not, or if the that weather sealant is holding it in place. I didn't hear any clicking or noises to that affect though. The lens just slid on to the housing with a little bit of pressure. I would hate to see my tail light lens shatter in my rear view mirror.
Thanks in advance for your input.
I'm obviously new to the forum, which explains why put my full name as the screen name instead of something a little more edgy. Duh!
Anyways, I just put some LX lenses on my GT, and I had a quick question. I used the new hardware provided in the box, but the center of the light bows out approximately 1/8". There is some minor flex when pressure is applied to the center of the light. I just want to know if this is an issue, or a common occurrence. I'm not quite sure if the clips seated properly or not, or if the that weather sealant is holding it in place. I didn't hear any clicking or noises to that affect though. The lens just slid on to the housing with a little bit of pressure. I would hate to see my tail light lens shatter in my rear view mirror.
Thanks in advance for your input.
#4
Thread
Thread Starter
Forum
Replies
Last Post
mrmrultimate
Texas Regional Chapter
2
09-10-2015 09:43 AM