My First Project Build 91 lx

Reply Subscribe

Thread Tools

Search this Thread

03-16-2009, 09:43 PM

#21

Chaoss84GT50

2nd Gear Member

Join Date: Jan 2009

Location: Colorado

Posts: 371

Quote:

Originally Posted by cassimus

well the only plus on my side is my buddy is a upr dealer so if anything like that occurs then hopefully that pull will get it set straight but hes running about 10 of his own foxes on it with no problem

well **** nevermind what I said, if my buddy was a UPR dealer then I would run there stuff in a heartbeat just because it could get fixed easier if there were any problems.

03-17-2009, 09:16 AM

#22

cassimus

3rd Gear Member

Thread Starter

Join Date: Jan 2007

Location: Georgia

Posts: 710

Quote:

Originally Posted by fs308

are you getting close to dealer price?

ya for over 1 k of parts its 800 and free shipping

04-11-2009, 09:24 PM

#23

cassimus

3rd Gear Member

Thread Starter

Join Date: Jan 2007

Location: Georgia

Posts: 710

pulled the 4cyl and tranny today will post pics later on......getting ready to start welding and tucking the engine bay while i save up for good satin paint for inside bay along with the whole k memeber assembly

05-06-2009, 10:18 PM

#24

cassimus

3rd Gear Member

Thread Starter

Join Date: Jan 2007

Location: Georgia

Posts: 710

My recent pics

these are my most recent photos of my project and when i took the junky ole 4cyl and tranny out to start on my wire tuck

Attached Thumbnails

My First Project Build 91 lx-scan0001.jpg

My First Project Build 91 lx-scan0002.jpg

My First Project Build 91 lx-scan0003.jpg

My First Project Build 91 lx-scan0005.jpg

05-06-2009, 10:22 PM

#25

cassimus

3rd Gear Member

Thread Starter

Join Date: Jan 2007

Location: Georgia

Posts: 710

heres more and oo yea the silicon on the sunroof is definitly going back to the way it should be and the quarter glass just recently was damaged by a falling limb during an ice storm just my luck

Attached Thumbnails