Going to longtubes
06-27-2009, 06:57 PM
5th Gear Member
Thread Starter
Join Date: May 2007
Location: Pittsburgh
Posts: 2,459
Going to longtubes
How much would going to longtubes hurt performance on a stock 5.0?
06-27-2009, 10:22 PM
Banned
Join Date: Dec 2005
Location: Lil' Rhody
Posts: 22,376
slight loss of low end torque, but you will pick up high rpm HP (where the 5.0 goes flat)
06-29-2009, 08:20 AM
5th Gear Member
Thread Starter
Join Date: May 2007
Location: Pittsburgh
Posts: 2,459
Should I go with 1 5/8" primaries or 1 3/4"? I'm planning on saving these for the sc stroker.
How much harder are they to get in?
06-29-2009, 09:26 AM
Banned
Join Date: Dec 2005
Location: Lil' Rhody
Posts: 22,376
1-3/4 would be best for an SC stroker, 1-5/8 on a stock engine-mild HCI
06-29-2009, 09:29 AM
5th Gear Member
Thread Starter
Join Date: May 2007
Location: Pittsburgh
Posts: 2,459
Would throwing 1 3/4 inch LT's on a mainly stock 5.0 reduce back pressure too much? I'm planning on a 2.5" H w/ cats into a 2.5" catback w/ muffers and 3" tips.
06-29-2009, 10:28 AM
6th Gear Member
Join Date: Feb 2005
Location: KY
Posts: 13,396
Quote:
Originally Posted by
Tony71502
How much would going to longtubes hurt performance on a stock 5.0?
i know when i had my 95 dynoed years ago with just lt, o/r h-pipe cai, pulleys and a fresh motor it made 209 275 so it felt plenty torquey
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Darrens07GT
GT S197 General Discussion
3
08-10-2015 03:59 PM
66_mustang_04
Pipes, Boost & Juice
7
02-19-2005 02:48 AM
matthockey32
V6 (1994-2004) Mustangs
8
09-17-2004 09:44 AM
04ShakinSteed
Pipes, Boost & Juice
17
08-20-2004 02:40 AM
mdvaldosta
Detailing
6
09-23-2003 01:34 PM